Service manual

www.enc.net.cn/en Tel/Fax:[phone] Examples
118
10.2 Terminal control running
10.2.1 Basic wiring diagram
Fig.10-2
10.2.2 Parameter setting
(1) Set parameter F8.01-F8.06 according to rated value of the motor.
(2) Set F0.00 parameter to 4~6 to choose VCI, CCI, YCI accordingly, can accept
frequency set signal within 0~10V.
(3) Set F0.02 parameter to 1，to choose terminal run command channel.
10.2.3 Realized function
(1) control forward run/reverse run of the motor by external on-off quantum.
(2) control speed of the motor by 0~10V signal.
(3) bear failure warning and output current indication function.
10.2.4 Application field
Used in field where need long-distance control to start/stop of the motor such as
blower, food, chemical machine, packing machine, transportation machine etc.
S
T
FWD
COM
TA
TC
M
U
E
motor
W
V
TB
REV
VCI
GND
AO1
GND
R
3 phase breaker
3 phase 380V
50/60Hz
forward run
reverse run
specified signal 10K
10V/5V
L1
L2
failure warning light
ammete
r
EDS1000
(1) If F5.08=0,namely 2 wire control mode 1: FWD and COM are closed，moter is
in forward run；REV and COM are closed，motor is in reverse run；FWD, REV
and COM are closed or opened together，the inverter stop.
(2) Set frequency is specified through VCI analog channel.
note