User's Manual

Test Beep Function
Press Mode button of Remote Transmitter, switch to Beep Mode.
Press Y button, Receiver Collar will beep, that means Beep Mode works.
Important: If the transmitter is in sleep mode (the LCD display is turned off) you
must press the “Y” button once to wake up the unit, then press the “Y” button again
to send the signal from the remote to the collar receiver. This applies to all functions.
Test LED light Function
Press LED light Button, LED light will turn on, means LED light button works.
Note:
I: If LCD of Remote Transmitter does not display, there is probably two reasons:
1. Light Standby: In order to save power, the Remote Transmitter will go into
Standby Mode if there is no operation after 20 seconds, press any button
except LED Light Button to activate Remoter Transmitter, LCD will display.
2. Deep Sleep: In order to save power, the Remote Transmitter will go into Deep
Sleep Mode if there is no operation after 1 minutes, press the Mode button to
activate the Remote Transmitter, LCD will display.
II: The receiver collar will go into deep sleep if no operation for 4 minutes. And any
movement by the dog will activate the receiver.
If the Receiver Collar has no response when you press the Y button, and the
Indication light of the Receiver Collar is not on either, you can shake Receiver
Collar or force the dog to move, and the indication light of the Receiver Collar
will show green, which means the Receiver Collar is active and will work.
III: When testing, choose any mode except LED light. When you are under Vibration
or Static Shock mode, Intensity Level cannot be at a stimulation level of 0, press
UP/DOWN to adjust.
-9-
-10-
LED light will turn on