User's Manual

-7-
-8-
4) Charge the transmitter for 2 hours.
5) After charging is complete, the red light will turn off automatically.
2. Charge the collar receiver:
1) Connect the charger connector to the charging jack.
2) Plug the charger into a standard outlet.
3) The red light will appear on the receiver.
4) Charge the receiver for 2 hours.
5) After charging is complete, the red light will turn off automatically.
3. Pairing the Remote Transmitter and Receiver Collar:
1. Charge the remote transmitter:
2) Plug the charger into a standard outlet.
3) The red light on the transmitter will light up.
1) Connect the charger connector to the charging jack.
4. Test static shock function:
1) Place the test light to the metal screws (ensure contact points are not
attached when attempting to test the shock function).
2) Select Static Mode by pressing the “Mode” button.
3) Select static stimulation level by pressing UP/DOWN button and choose
between 1-100 stimulation levels.
4) Press “Y” button, and the LED will flash on.
Important: Please see diagram below on how to attach the test light:
Important Notice: If wishing to test the static function on yourself, remember
to place your finger or hand against both contact points. Otherwise, the connection
won't be completed and no stimulation will be felt.
1) Power on the Collar Receiver by pressing the PAIR button on the Collar Receiver.
A beep will sound, and the indicating light will turn on.
3) Pr ess the Y butt o n on the Remot e Transm itte r once the Rece iver Coll ar
b eeps . When the Remo te Transmi tter and Col l ar Recei ver are paire d
s ucce ssfu lly, th e Coll a r Rece i ver will bee p again , and the indic atin g light
w ill turn off.
4) If needing t o pair a second Collar Receiver, follow the s a m e steps but first
press 1/2 button to different channel.
Note: Pairing has to be finished within 10 seconds after the 1st beep from the
Receiver Collar. Meaning, you have to press the Y button within 10 seconds of
the 1st beep for pairing to be completed.
2) Press and hold the PAIR button for 3 seconds until beep sounds, the indicating
light will begin to flash quickly.
Static Shock Stimulation Tester
In your package that you received, you will find a clear almost translucent plastic
piece that has a light bulb/fuse in the middle of it. This is your Static Shock
Stimulation tester. This component DOES NOT attach to the Collar Receiver by
any means and is only for testing the static shock mode. To test static shock
function, follow these steps:
Test Vibration Function
Press Mode button on the Remote Transmitter, switch to Vibrate mode, confirm
us ing the LCD display that the stimula tion level is not at 0, you can p ress UP/
DOWN button on the right side to adjust.
Press Y button, Remote Collar will vibrate, that means Vibration Function works.