User's Manual

-5-
Key Definitions
Y
5. U
6. Led Light Button
7. Channel Button
8. Launch Button
9. Mode Button
10. Transmitter Charging
Jack
11.Contact Points
12. Button
13. Receiver Charging
Jack
p/Down Button
14. Rubber Cover
Channel 1
Channel 2
Low Battery Indicator
1. Antenna
2. LED Light
3. LED Indicator
4. LCD Screen
Light Mode
Static Shock Mode
1-100 Level
Vibration Mode
Beep Mode
1. Antenna: Transmits the signal from the Transmitter to the Receiver Collar.
2. Led light: This light will be on when pressing the LED light button.
3. LED Indicator: This light will flash when the “Y” button is pressed. The light
will be activate when charging as well.
4. LCD Screen:
Static mode: With this mode selected, pressing the “Y” button will cause the
receiver to emit shock.
-6-
Vibration mode: With this mode selected, pressing the “Y” button will cause
the receiver to vibrate.
Beep Mode: With this mode selected, pressing the “Y” button will cause the
receiver to emit a beep sound.
Light Mode: With this mode selected, pressing the “Y” button will cause the
LED light on the receiver to flash red once every second. Its primary purpose
is to help locate your pet.
Channel 1: Indicates the selection of the first collar receiver.
Channel 2: Indicates the selection of the second collar receiver.
5. Up/down buttons: Selects intensity level for Vibration and Static Shock.
6. Led light button: When pressing the LED light button, the LED light on the
transmitter will be on.
7. Channel button: Pressing this button will swap between the first and second
collar receiver.
8. Launch button: Sends the signal from transmitter to receiver, resulting in
stimulation, beep or light, depending on your mode selection.
9. Mo de b ut to n: P ress t hi s b ut to n t o s wi tc h b et ween m od es. The re a re 4
mod es : S ta ti c, Vi brat io n, Bee p a nd l ig ht m od e.
10. : Insert charging connector into charging hole to
charge the Transmitter.
Transmitter Charging Jack
11. Contact Points: Helps deliver safe static correction.
12. button
2) Pair the transmitter and receiver.
: 1)Turn ON/OFF the receiver collar.
13. Receiver Charging Jack
charge the receiver.
: Insert charging connector into charging jack to
14. Rubber Cover: Seals charging jack to keep dust and water from entering. If
not sealed, then the item will not be waterproof.
HOW TO USE
Note: Please charge before using the product! Please ensure you're putting
the correct side of the cable into the USB charger port as the connector is not
the same size on both ends.