User's Manual

Step
2
Powering on and off the Remote Transmitter
There is no need to turn off the transmitter. When no button has been
transmitter, the unit turns off automatically. Press any button and the transmitter
will power back on automatically.
pressed on
Powering on and off the Collar Receiver
Press the ON/OFF button on the receiver to power the unit on or off. When
receiver is powered on, the indicating light will flash green.
the
Pairing Collar Receiver to Transmitter
Note: Transmitter and receiver are pre-paired when leaving our
facility. In case the pairing is not established or you would like to repair the units,
please follow the instructions below:
manufacturing
1. Power on the Collar Receiver by pressing the ON/OFF button on the Collar
Receiver.
2. Press and hold the ON/OFF button for about 3 seconds until a beep sounds, and
the indicating light will begin to flash quickly.
3. Press any button on the transmitter once the Collar Receiver
Remote Transmitter and Collar Receiver are paired successfully the indicating
light will stop flashing quickly.
beeps. When the
4. If needing to pair a second Collar Receiver, follow the same steps but
your Toggle Switch in the other direction.
first push
Test the Training System Functions
The testing methods will help determine whether the training system is
as intended and will also teach you how to operate the system. Please ensure that the
pairing process is complete before attempting to test the functionality.
functioning
Testing the Electronic Pulse Stimulation
Electronic Pulse Stimulation Tester
In your package that you received, you will find a clear almost translucent
piece that has a light bulb/fuse in the middle of it. This is your Electronic Pulse
Stimulation tester. This component DOES NOT attach to the Collar Receiver by any
means and is only for testing the static shock mode. To test the Electronic Pulse
Stimulation, follow these steps:
plastic
1. Put the test light over the Electrodes of the Collar Receiver you wish to test.
2. Ensure the Toggle Switch is in the correct position for the Collar Receiver
testing.
you're
3. Adjust the Intensity Dial off of 100.
Step
3
Note: Before first use, charge the Remote Transmitter and Receiver Collar
completion.
until
ENEN
6. Remove the charging connector, and replace the rubber cover to protect
Charging Port.
the
-8- -9-
Note：If the unit stops powering on or communicating with each other, please
simply recharge the device, it will reset and begin to operate normally.
5. If done correctly, the test bulb should flash orange indicating the electronic
pulse stimulation is operating correctly.
4. Press the Static Shock Button on your Remote Transmitter.