User's Manual

-9-
-10-
Pairing Collar Receiver to Transmitter
Note: Transmitter and receiver are pre-paired when leaving our manufacturing
facility. In case the pairing is not established or you would like to repair the units,
please follow the instructions below:
Fit the Collar Receiver:
Testing the Vibration Functions
1. Power on the Remote Transmitter, and adjust the Intensity Dial off 100.
2. Press the Vibration Button on your Remote Transmitter.
3. If done correctly, the Collar Receiver will vibrate.
Important: The proper fit and placement of the Collar Receiver is essential for
training. The contact points must have direct contact with the dog's skin.
effective
(1) To fit the Collar Receiver, attach the Collar Strap to the Receiver.
(2) With the dog standing in front of you, place the Collar Receiver around the
so the receiver box and Contact Points are on the underside of your dog's neck,
making direct contact with the dog's skin. If direct contact is not possible, shaving
some fur away, to ensure good
contact is recommended.
dog's neck,
(3) Fasten the collar strap. The fit should be snug, but not taut. A finger should be
able to
be placed beneath the collar strap when around the dog's neck.
3. Press the Static Shock Button on your Remote Transmitter.
4. If done correctly, the test bulb should flash orange indicating the electronic pulse
stimulation is operating correctly.
Note: If wanting to test the shock function on yourself, please ensure your
is across both contact points to ensure the connection is complete. Otherwise, user will
feel no stimulation.
finger or hand
Testing the Sound Functions
1. Ensure the Toggle Switch is in the correction for the Collar Receiver you're testing.
Press the Sound Button on your Remote Transmitter.
2. If done correctly, the Collar Receiver will emit sound.
(4) Allow the dog to wear the Collar Receiver for several minutes and check the
again. The dog will soon become more familiar with the Collar Receiver, so it is crucial
to ensure the fit comfortable and flattering.
strap
CAUTION: RISK OF SKIN DAMAGE
For comfort, safety and effectiveness of this product please check the fit of the dog's
collar frequently. If observing any skin irritation, immediately discontinue use of the collar
for a few days. If the skin condition persists beyond 48 hours, consult a veterinarian.
These collars can cause pressure necrosis, commonly known as bed sores, if used
incorrectly and is often misidentified as burns.
Do not attach a leash to the collar, which can result in squeezing the Contact
Points too tightly against your dog's neck.
The design of the Collar Receiver discourages constantly wearing the device. Petrainer
recommends the collar not be worn for more than 12 hours out of every 24-hour period.
Most dogs feel uncomfortable when wearing the collar for the very first time. Do not use
any functions until the dog is accustomed to the collar.
Petrainer suggests giving the dog, the vibration stimulation before following it with a
static shock. After training for a while using this method, the dog will be aware that after
vibration comes a static shock. Vibration will act as a warning, and static shock only acts
as a menace that might be necessary sometimes.
2. Turn on the Remote Transmitter and adjust the Intensity Dial off 100.
Step
3