User's Manual

Table Of Contents

-12- -13-

CAUTION: RISK OF SKIN DAMAGE

For comfort, safety and effectiveness of this product please check the fit of the

collar frequently. If observing any skin irritation, immediately discontinue use of the

collar for a few days. If the skin condition persists beyond 48 hours, consult a

veterinarian. These collars can cause pressure necrosis, commonly known as bed sores,

if used incorrectly and is often misidentified as burns.

dog's

Do not attach a leash to the collar, which can result in squeezing the Contact Points too

tightly against your dog's neck.

The design of the Collar Receiver discourages constantly wearing the device. Petrainer

recommends the collar not wearing for more than 12 hours out of every 24-hour period.

Most dogs feel uncomfortable when wearing the collar for the very first time. Do not use

any functions until the dog is accustomed to the collar.

Petrainer suggests giving the dog, the vibration stimulation before following it with a

static shock. After training for a while using this method, the dog will be aware that after

vibration comes a static shock. Vibration will act as a warning, and static shock only acts

as a menace that might be necessary sometimes.

Pairing Collar Receiver to Transmitter

Note: Transmitter and receiver are pre-paired when leaving our manufacturing

facility. In case the pairing is not established or you would like to repair the units,

please follow the instructions below:

1. Press Power Button on the Remote Transmitter once to turn it on.

2. Power on the Collar Receiver by pressing the Power button once on the Collar

Receiver, it with comes a beep.

3. Press and hold the Power Button for about 3 seconds until a beep sounds, and the

indicating light will begin to flash quickly.

4. Press any stimulation button on the transmitter to pair to Receiver Collar. When

the Remote Transmitter and Collar Receiver are paired successfully the indicating

light will stop flashing quickly.

5. If needing to pair a second Collar Receiver, follow the same steps but first push

your Toggle Switch in the other direction.

Note:

If the unit stops powering on or communicating with each other, please simply

recharge the device, it will reset and begin to operate normally.

Re-thread the collar

Regular Maintenance

Ensure Contact Points are not too tight on a weekly basis.

Rinse the Contact Points with alcohol on a weekly basis.

Check the dog's neck for irritation and wash the dog's neck on a weekly basis.

Step