V20190311 EN User Manual Training Collar System General Training Tips Traoning Manual www.ipets-mall.
Table of Contens Important Safety Information Important Safety Information.......................................................................... ............................................ 3 WARNING: NOT FOR AGGRESSIVE DOGS. Do not use this product if your dog is aggressive, or if your dog is prone to aggressive behavior, Aggressive dogs can cause severe injury and even death to their owner and others.
Components PET616A-3(1 for 3) PET616A-1(1 for 1) Remote Transmitter Test-light bulb Collar-receiver Test-light bulb Charger Charger Adjustable TPU Belt USB Cable Contact Points Three sets of Contact Points Collar-receiver PET616A-2(1 for 2) Remote Transmitter USB Cable Test-light bulb Collar-receiver Adjustable TPU Belt USB Cable -4- Charger Two sets of Contact Points Adjustable TPU Belt -5- Remote Transmitter
How the dog training system works? Petrainer products are reliable, effective, and comfortable for large or small dogs. The system assists in controlling your dog without a leash in a range up to 330 yards away! Instantly send a signal from the Remote Transmitter, which activates your dog's Collar Receiver. The dog will receive an annoying but safe, harmless stimulation.
Transmitter Charging Jack: Charges the battery of the Remote Transmitter when connected to a power source. Receiver Indicator Light: Belt Clip: Allows for the possibility of hands free training. Rubber Cover: Protects the internal components of the Remote Transmitter from dust and water. Always remember to replace after charging is complete. LCD Display: Displays transmitter battery life, intensity level and receiver selection. ON/OFF Button: Powers on or off the Remote Transmitter.
Note: If wanting to test the shock function on yourself, please ensure your finger or hand is across both contact points to ensure the connection is complete. Otherwise, user will feel no stimulation. Note: Before first use, charge the Remote Transmitter until completion of the charging process. Testing the Vibration Functions 1. Power on the Remote Transmitter, and adjust the Intensity Dial off 100. 2. Press the Vibration Button on your Remote Transmitter. 3.
CAUTION: RISK OF SKIN DAMAGE Note: For comfort, safety and effectiveness of this product please check the fit of the dog's collar frequently. If observing any skin irritation, immediately discontinue use of the collar for a few days. If the skin condition persists beyond 48 hours, consult a veterinarian. These collars can cause pressure necrosis, commonly known as bed sores, if used incorrectly and is often misidentified as burns.
Frequently Asked Questions: Troubleshooting How old does the dog have to be before using the system? Your dog should have learned basic obedience commands such as, “sit” or “stay.” The Collar Receiver might be too large for dogs under 15lbs. My dog is not responding after the training system installed successfully. Once my dog completes training and is been obeying my commands, will he have to wear the collar? Probably not, but you may try to reinforce training with the collar.
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna.
(4) Use a long leash fastened to a non-metallic collar to help the dog's learning. Ensure the additional collar and leash does not interfere with the Contact Points on the Collar Receiver. Do not use the remote training collar without a long leash until your dog is fully trained. (5) More success will occur by teaching the dog a command first before trying to reinforce the command with the Remote Transmitter. (6) For basic obedience training, vibration is more useful.
2. Release the Stimulation Button immediately once your pet is sitting, and verbally praise him. 3. If your pet ignores the stimulation, increase the Intensity Level until he/she responds. 4. Practice this exercise in several different areas and use different people for distractions. Digging It is important to first understand why your pet is digging. Many dogs, such as terriers, were bred to flush out prey, and digging is very innate to them.
Perfecting Basic Obedience Note: When we refer to stimulation button this will change depending on your model, for models PET998DR, PET998DB, this will be your “Y” button. For any other models, there should be a stimulation button for each type of stimulation (static shock, vibration and beep). The “Sit” Command 1. Put a separate, non metallic collar on your pet's neck above the Receiver collar and attach at least a 10-foot leash. Note: Be sure the extra collar does not put pressure on the Contact Points.
