User's Manual

14. When the temperature of probe in the steak reaches 135 °F the LCD backlight will flash
green.
15. When the temperature of probe in the steak reaches 150 °F MEDIUM the receiver will beep
and the LCD backlight will flash red.
16. Press STOP to turn off the alert.
15. Turn off grill. Remove the probe sensor from steak. Always wear a heat resistant glove to
touch the stainless steel probe sensor or wire during or just after cooking. Do not touch with
bare hands.
16. Clean the stainless steel probe and dry thoroughly after each and every use.
17. Turn off the transmitter.
HELPFUL HINTS
If the receiver and/or the transmitter display LLL or HHH instead of the probe temperature, wait
for probe to reach room temperature. If LLL or HHH is still displayed it is likely the internal
probe wire has shorted out either through moisture or heat damage.
Using the Timer
Count down
1. Press MODE to select timer mode. The upper display will show a small TIMER and 0:00.
2. Press HR and MIN button to set the timer. Press START/STOP button to start countdown.
“T” will blink for every second.
3. To stop the countdown process, press START/STOP button. The “T” becomes solid.
4. Press HR & MIN buttons together to clear the setting back to 0:00.
Note: The minimum setting for the timer is 1 minute. When the timer counts down below 1 hour
1:00 the display will change to 59’59” display advising 59 minutes 59 seconds. The seconds will
be shown counting down then. When the countdown reaches 0’00” the timer starts counting up
and it will beep for 60 seconds. The timer and “ST” will blink. Press the START/STOP button to
stop beeping. When the count up reaches 23:59:59 (59 seconds are not displayed) the display
will turn to 0:00, the unit beeps and “ST” will blink for 60 seconds.
Count up
1. Press MODE to select timer mode. The upper display will show a small TIMER and 0:00.
2. Press START/STOP button to start count up. The “S” will blink for every second.
3. To stop the count up process, press START/STOP button. The “S” becomes solid.
4. Press CLEAR button to clear the setting back to 0:00.