User's Manual

2. Turn transmitter on by pressing and holding the ON-OFF/°F°C button for 2 seconds.
3. Turn the receiver on by pressing and holding the ON-OFF/°F-°C button for 2 seconds.
4. Registration is complete when the receiver shows the probe temperature.
Auto Off feature:
The receiver will turn off automatically if it hasn’t receive the temperature signal from the
transmitter for more than 30 minutes ,A beep will sound for one minute before it shuts
down. However, the Auto Off feature will be automatically disabled if the timer is running.
The transmitter will turn off automatically if the temperature measured is always lower than 50
C (122F) in 120 minutes.
Measure meat temperature to USDA doneness temperature range
1. Press MODE to select thermometer mode. The upper display will show a small MEAT and a
meat type such as BEEF.
2. Press MEAT to select meat type. PROG (program), GBEEF (ground beef), GPOUL (ground
poultry), BEEF, VEAL, CHCKE (chicken), PORK, POULT (poultry), LAMB & FISH.
3. Press TASTE to select the level of doneness for the meat type selected. RARE, MED RARE,
MEDIUM, MED WELL and WELL DONE.
Note: The temperature displayed to the right of the actual meat temperature PROBE TEMP will
show the preset temperature TEMP SET according to USDA doneness levels. Example: Beef will
be Well Done at 165 °F.
4. Once the temperature of meat reaches the preset doneness level the receiver will beep and the
LCD backlight will turn red.
Measure meat temperature set to your specific taste
1. Press MODE to select thermometer mode. The upper display will show a small MEAT and a
meat type such as BEEF.
2. Press HR or MIN to raise or lower the set temperature. As you press HR or Min the display
changes to PROG (program). Holding the button will raise or lower the temperature setting
rapidly. Pressing MEAT will return you to the preset USDA ranges.
3. Once the temperature of meat reaches the preset doneness level the receiver will beep and the
LCD backlight will turn red.
Using the Timer
Count down
1. Press MODE to select timer mode. The upper display will show a small TIMER and 0:00.