User's Manual

IV. Points for attention
1. this product G-Sensor built-in sensor, when the product is working, any sloshing, falling,
collision, tilting, rising, falling and other movements willimmediately stop working.
2. this equipment uses the high power laser as the heatemission source, do not use the eye
to look directly atthe laser head, althoughhas the G-Sensor device, but direct view at the
weak blue light , will hurt the eye.
3.when the engraving machine works, observe the carved spot throughthetranslucent bracket.
4.please wear goggles.
5. Childrenunder the age of 12 are forbidden to operate, if you need tooperate, pleasebe
accompanied by adults.
6.this product should be used in a supervised place.
7.this product is not used for along time, please use packaging box to avoid dustinto the XY
shaft caused bymovement is not smooth, if the product is used for along time, please
properlyapply lubricating oil to the XY silk rod and opticalshaft.
V. WARNING
Do not use the laser light source of this product to illuminate any object
other than the object to be engraved, especially human eyes.