User's Manual

6.2 Cutting configuration:
If the picture in "contour mode" click send, then there will be cutting configuration options, first
select the material, cutting power value should be the largest and constant, the slower the cutting
deeper. Usually high hardness materials need to reduce the speed of cutting, or after the
completion of the cutting click "again" for multiple original path cutting, in order to achieve the
purpose of cutting for different materials.
After setting up the configuration, click the "save" button in the upper right corner to enter the
engraving page, if you need to reset the engraving configuration when carving, you can click
"pause engraving" and then click "configure" button on the left of "pause engraving" to set up,
after setting up click "save" and then click "continue engraving" can.