Instruction Manual

Scope of application
◆
B81X
Bluetooth speaker
Please read the instruction manual before
using B81X Bluetooth speaker
3.
Bluetooth Speaker On/Off
2.MICRO USB
4. LINE IN
108mm
54mm
56mm
Interface diagram
Product Parameters
◇ :
◇ Audio output power: 3W
◇ Signal-to-noise ratio: ≧ 90db
◇ Built-in lithium battery: 300mAh
◇ Playback time: about 2 hours
◇ Charging time: about 1.5 hours
Instructions
Input voltage
DC 5V
/
2A
Play the Music
In Bluetooth Speaker Mode:
◇ Shift the bluetooth speaker On/Off button to on
option to begin the bluetooth speaker mode.
◇ Open the bluetooth function on mobile phone to
search the bluetooth name" " to pair,then
begin playing music.
The line interface can be connected to
computers, mobile phones and other mobile multimedia
devices to play music.
ZTS027
Line-in Port:
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment.
NOTE: This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
FCC Statement: This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV
technician for help.