Instruction Manual
Table Of Contents
Scope of application
◆
Please read the instruction manual before using
B81 wireless charging Bluetooth speaker
3.Bluetooth Speaker On/Off
1.
Wireless Chargering
Transmitter
2.MICRO USB
4. LINE IN
1
0
8
m
m
54mm
5
6
mm
Interface diagram
Product Parameters
Instructions
◇ When the wireless charger is charging the mobile
phone, the blue light is always on.
Play the Music In Bluetooth Speaker Mode:
◇ Shift the bluetooth speaker On/Off button to on
option to begin the bluetooth speaker mode.
◇ Open the bluetooth function on mobile phone to
search the bluetooth name" " to pair,then
begin playing music.
The line interface can be connected to
computers, mobile phones and other mobile multimedia
devices to play music.
Note: The battery only powers the bluetooth speaker
part, not for wireless charging.
ZTS027
Line-in Port:
◇
Input voltage
:
DC 5V
◇ Audio output power: 3W
◇ Wireless charging power: 5W
◇ Signal-to-noise ratio: ≧ 90db
◇ Wireless charging output: 5V / 1A
◇ Built-in lithium battery: 300mAh
◇ Playback time: about 2 hours
◇ Charging time: about 1.5 hours
◇ The red light is on when connect the wireless
charging bluetooth speaker to the DC 5V
adapter or other mobile power device.
◇ Place the mobile phone or other mobile devices
with wireless receiver on the wireless charging panel
of the wireless charging bluetooth speaker, and the
mobile devices displays the charging status.
◇ If the mobile phone does not have a built-in wireless
receiver, you need to connect the phone to a wireless
receiver board. Then put it on the wireless charging
panel, the mobile phone displays the charging status.
B81
bluetooth speaker with wireless charger
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.