Instruction Manual

This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (a ) This device may
not cause harmful interference, and (b ) this device must accept
any interference received, including interference that may cause
undesired operation. Any Changes or modifications not expressly
FCC Warning
◇ Do not frequently fall or bump the device, which may
cause the explosion.
◇ Do not let children play or use the device when adult is
not presented.
◇ Do not put or use the device in the environment of low
temperature or humidity, the normal environment
temperature should be 0-50℃.
◇ Do not disassemble or repair the device personally.
◇ Do not put the magnetic stripe like bank card close to
the device, which
may cause the magnetic failure.
◇ Do not put the device close to medical instruments in the
range of 20cm. Which may cause signal interference.
◇ Please make sure the charged device being off the protect
cover before directly charging to wireless charger.
◇ Please plug off the adapter when not using the device,
which can save the life time and avoid the damage.
Safety Infor m a t i o n
Caution:
Please
read following cautions to avoid the unexpected
emergency during using the wireless charger .
◇ Do not directly touch the device when it is overheated,
which may bring scald hurt.
◇ Do not put the device in the place close to Heater,
Microwave, Electronic Cooker, which may cause the
device overheated and lead a fire.
approved by the party responsible for compliance could void the
user's authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a ci
rcuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help.The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable
exposure condition without restriction.
3.Bluetooth Speaker
On/Off
4.Bluetooth Speaker
Indicator
5.MICRO USB
wireless charger bluetooth speaker
Range of application
Main Function Instruction
1.
Transmitter
Wireless Charger
2.Wireless Charging
Indicator
Please read the instruction manual before
operating the wireless charger bluetooth speaker
B80
75.7mm
75.7mm
◆
Product Parameters
Instructions
◇ The red light is on when connect the wireless
charging Bluetooth speaker to the DC 5V / 2A
adapter or other mobile power device.
◇ Place the mobile phone or other mobile devices
with wireless receiver on the wireless charging
panel of the wireless charging Bluetooth
speaker, and the mobile devices displays the
charging status.
◇ If the mobile phone does not have a built-in wireless receiver,
you need to connect the phone to a wireless receiver board.
Then put it on the wireless charging panel, the mobile phone
displays the charging status.
◇ When the wireless charger is charging the mobile
phone, the
blue light is always on
Play the Music In Bluetooth Speaker Mode:
◇ shift the Bluetooth Speaker On/Off button to ON option to
begin the Bluetooth Speaker mode.
◇ Open the Bluetooth function on mobile phone to search the
Bluetoothname“ B80” to pair,then begin playing music.
◇ Input:DC 5V/2A
◇ Audio Output Power:3W
◇ Wireless Power:5W
◇ SNR:
≧90db
◇ Wireless Power Output:5V/1A
◇
Wireless Charging Standard:QI
◇ Built-in polymer-Li battery:300mAh
◇ Working time:about 1.5 hours
◇ Playing time:about 2 hours
The distance between user and products should be no
less than 20cm