Users Manual

GettingConnected
The transmitter is easily wired into
any system, just follow these steps:
1. Attach the antenna to the transmitter
(Arrow #1)
2. Connect a cable from the Audio
Output on the music source to the
RCA Audio Input located on the Silent
Symphony transmitter. (Diagram pg 6)
3. Connect a microphone to the 1/8"
input on the transmitter to be mixed
with the audio signal. (Diagram pg 6)
4. Select the Transmission Power Level.
(Pg 4, Item #3)
5. Select from one of the available
frequencies to broadcast on with the
Channel Select switch. (Arrow #2)
6. Power your headset receiver(s) ON and
select the appropriate channel to listen
with the Tune button.
7. Adjust the headset receiver volume to
a comfortable listening level.
With this setup, any audio that is fed
into the transmitter will be broadcast
wirelessly to all headset receivers tuned
to the same channel and that are within
its operational range.
Note: The transmitter will
is detected after 5 minutes.
Page | 5
R
L
TYPE-C
DC 9V
2
1
POWER
OFF
LOW
HIGH
MIC
CHANNEL