User's Manual

of the mouse is correct.
The inner circuit design of the low-voltage test of batteries. When in shortage
of battery tension, the transparent lampshade before the mouse wheel flash in red light,
reminding you recharge in time; Meanwhile low-voltage alarming signals will deliver
to the receiver on which the “COM” red light will continuous flash unless no alarming
signals exits in following transmission.
Intelligent electricity-saving technology is adopted for the optimization for
electricity saving. When moving the mouse, the red LED light on the bottom is brightest
in the fully loaded condition; when stopping moving, the LED light quickly dark down
to saving electricity; when up to 8 minutes no using, the LED light go out as in sleeping
condition with the mouse wholly unworking and costing little electricity. The wakening
circuit, specially designed to the sleeping condition, can automatically turn on the
red LED light to recover function of mouse once it feels your touching on the top of
the mouse; Meanwhile the mouse awakening function is available by pressing any key
or roll once the mouse wheel.
Manual “turnoff” function of mouse, is designed to avoid accidental awakening when
you are on a trip. pressing the “connect” button at the bottom of the mouse for more
than 3 seconds to shut the mouse, the red LED light will die out as a “turnoff” condition,
then pressing any other keys or rolling the wheel or any other induction methods,it
is all useless. Press the “CONNECT” key again to release the “turnoff” condition,then
the mouse can be operational again.
A shortcut for you: all the optical mouse are more electricity-saving by using
on light surface than dark one.
1. With a little force to pull out the battery cover on the “open” location on the
back of keyboard.
2.Install the two AA alkaline batteries in the battery slot according to the instructed
direction
3.Carefully recover the battery cover
The low-voltage alarming circuit is set in the inner keyboard. So when the battery
voltage is insufficient, the alarming signals from the keyboard to receiver will result
in continuous flashing of the red “COM” key on the receiver until no alarming signal
follows from keyboard. Suggest changing the batteries in time once the situation
exits and using the alkaline batteries with the same specification and not to mix in
using old battery.
1. Com：Communication indicator light/low-voltage alarming light for batteries.
· The indicator light will shine when the receiver incepts the suitable wireless data
from mouse or keyboard.
·When the battery tension of the wireless mouse or keyboard is insufficient, it will
give out the alarming signals to receiver and the indicator light will flash
continuously unless no alarming signals from mouse or keyboard.
When the
2. Caps: capitalization indicator light
3. Scroll: lock-up indicator light
4. Num:Number key indicator light
·There are two PS/2 connectors for receiver, one for computer mouse and the other
for keyboard. Turn off the computer before connecting and pay attention to the same
color of the plugs and matched sockets.
·The above “connect” key on the receiver is used for connecting the mouse and
keyboard. Take the following description of the communication channel for reference
to the operating steps. The “COM” light will shine once the receiver incepts right