User's Manual

3、Long press POWER to shutdown the blue-tooth speaker.
4、LED off if shutdown the speaker.
Pairing the Device:
1、Place the speaker near the Blue-tooth-enabled device.
2、Long press POWER to start the blue-tooth speaker, blue LED flashes, the speaker is now in pairing mode.Follow the
instructions of your device to search for the speaker.
2、The speaker is called “Q10”, enter the PIN”0000” if need.
3、Blue LED light, the completion of the pairing, while the voice prompts. The speaker is in the state of pairing the last
device default in the first 3 seconds after starting. If failing to pair, the speaker will be in state of pairing automatically.
LED Indicator
1、Charging: Red LED on
2、Fully charged: Red LED off
3、Pairing Mode: Blue LED flashes.
4、Connected: Blue LED slow flashes
Safety and General Information:
1、Do not expose the device to water or attempt to disassemble the device. If the device is exposed to water or disassembled,
the user may be risking an electronic short.
2、Do not use this products in an aircraft or in hospital.
3、Do not expose the device to direct sunlight, heat and flame.
4、Device may be warm while charging. It is normal.
5、Changes or modifications to this equipment not expressly approved by the party responsible for compliance could avoid the
user’s authority to operate the equipment.
Key’s Sketch Map: