User manual

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.
3
Chapter 1: Product Introduction
VTC 7120-BK Series User Manual
Hardware Specifications
CPU
Intel
®
Celeron
®
847E 1.1GHz
Main Chipset
QM67
Memory
One 204-pin SO-DIMM DDR3 1333 up to 8GB. 2GB (default)
Expansion
1x Mini-PCIe socket (PCIe + USB) for WLAN option
1x Mini-PCIe socket (USB) for WWAN option
1x Bluetooth module for option
1x on board uBlox NEO-6Q GPS module or optional GPS module with dead
reckoning
I/O Interface-Front
1x Line-out, 1x Mic-in (for WWAN CM8000 voice communication)
2x SIM card socket (selectable)
1x System reset button
1x USB 2.0 host type A connector
1x Power button
1x CFast with protection cover
1x Accessible 2.5” SATA II SSD tray
4x LED’s for power, storage, WLAN/ WWAN and GPIO
I/O Interface-Rear
1x 9~36VDC input with Ignition
1x 12V/4A DC output, SMBus
1x DB26 LVDS interface with 12V and USB2.0
1x DB15 VGA
1x DB9 RS-232 (default) or OBDII (optional)
1x DB9 RS-422/ 485
1x DB9 female connector for 4x DI and 4x DO
(Digital Input)
Input Voltage (Internal Type): 5VDC TTL (default)
Input Voltage (Source Type): 0~30 VDC
(Digital Output)
Digital Output (Sink Type): 5VDC TTL (default), max current: 20mA
Digital Output (Source Type): 0~30VDC, max current: 250mA
2x USB 2.0 host type A connector
2x RJ45 with LEDs for 10/ 100/ 1000Mbps Ethernet
1x Line-out, 1x Mic-in
1x SMA-type GPS antenna connector
4x Antenna hole reserved for SMA-type antenna connector (WWAN/
WLAN/ BT)
Others
1x PCI-104
1x G Sensor
Note: If PCI-104 installation is needed, please contact NEXCOM for further information.
Power Management
Selectable boot-up & shut-down voltage for low power protection by
software
Setting 8-level on/off delay time by software
Status of ignition and low voltage status can be detected by software
Support S3/ S4 suspend mode
Dimensions
260mm (W) x 176mm (D) x 66.5mm (H) (10.24”x 6.93”x 2.59”)
3.25 Kg (7.16 Lb)
Construction
Aluminum enclosure with fanless design