Product Specs

深 圳 天 好 光 电 有 限 公 司
SHENZHEN DAYBETTER OPTO-ELECTRONICS CO.,LTD ★秘
密★
6
Highly recommend users choose this method to configure network.
It also supports powering off and up 3 times to enter into the network configuration state. That is, in
the power-on state, after “power off- power on-power off-power on-power off-power on” , the product starts
to enter into network configuration state, which should not exceed 10 seconds per power-up state, this
requirement is actually very lenient. This method can be written in the manual as the 2nd method, and users
can use this method when the remote control is not available.
It is recommended that users plug and unplug the connecting wires of the controller and power adapter,
and do not plug and unplug the plug of the power adapter to avoid safety problems.
Network configuration status: Red light flashes with 100% brightness, and frequency is 1 time/sec.
The remote control button can still take effect in the network configuration status. The network
configuration continues in the background, and the duration of the network configuration is 3 minutes.
Network configuration success: the light changes from red flashing to green long light. However, if
there is a remote control operation during the process, then the remote control operation is executed.
Network configuration timeout: If the network configuration is not succeeded within 3 minutes with no
remote control button operation, the network configuration will time out. The red light will long light with
100% brightness.
As long as the device is not successfully configured, it will be in the configuration state by default for
the first 3 minutes of each power-up, so that users can try to configuring directly after powering up. Due to
the power-off memory function, the light strip will continue the state of the last light when it is powered on,
instead of the red light flashing, unless the user does not change the state of the light with the remote control.
5.2 Power off memory
Support power-off memory. That is, after power off and power on again, the light strip will continue the
last state.
The controller will remember it only after 3 seconds of an operation, so if the user presses the remote
control and then immediately power off (less than 3 seconds), the light strip will light up according to the
previous state, not the last operation.