Instruction Manual

7
select this item. Then you can do below:
 DELETE HANDSET
This function allows the user to delete a handset registration from the base（Cannot delete local）。
1) Press
key, the first show is DELETE HS.
2) Press
key to enter, the user will be prompted to enter the PIN code.
3) Input the correct 4-digit pin code using digit key (the default PIN code is 0000）.
4) Press ∧ or ∨ key to scroll the handset names list up and down.
5) Press
key to confirm. The delete handset will be deleted from the list on registered handset on the
base, and the handset will behave according to the out of range condition.
Note: In idle mode, press and keep
key for 5s, IN USE/CHARGE LED flashes, then press key 7
times swiftly, the IN USE/CHARGE LED flashes quickly. Then all the handsets logout the base successful till
IN USE/CHARGE LED die out.
 DIAL MODE
The user can select to change the mode will dial.
1) Press
key, then using ∧ or ∨ key to select DIAL MODE item.
2) Press
key to enter, and the display shows TONE.
3) Press ∧ or ∨ key to select TONE or PULSE dial mode.
4) Press
key to confirm your selection.
Note: According to your telephone lines or PABX systems you may need to change the dialing mode
between Tone and Pulse.
 FLASH TIME
The user can select the flash time (100ms, 300ms, 600ms and 1000ms) to meet your telephone line or PABX
requirement.
1) Press
key, then using ∧ or ∨ key to select FLASH TIME item.
2) Press
key to enter.
3) Press ∧ or ∨ key to select the desired flash time among 100ms, 300ms, 600ms and 1000 ms.
4) Press
key to confirm your selection.
 MODIFY PIN
Some functions (including handset delete and base default) require a PIN code. The default PIN is 0000, but
you are able to change to your personal 4-digit PIN.
1) Press
key to confirm. Then using ∧ or ∨ key to select MODIFY PIN item.
2) Press
key to confirm, and the display shows PIN?
3) Entry the existing PIN code for the base and handset by using numerical keys (the default PIN code is
0000), then press
to confirm.
4) If the old code is validated, the display shows NEW PIN, enter a new PIN code (4 digits), press
to
confirm.
5) The display shows REPEAT, input the new PIN code again.
6) Press
to confirm, the code will be stored and a tone sounded.
 BASE DEFAULT
This function allows the user to restore the base setting to the factory default.
1) Press
key, then using ∧ or ∨ key to select BS DEFAULT item.