Instruction Manual

12
 TYPE I
After you have applied the caller ID service, you can see the caller party phone number during an incoming
ring.
 TYPE II
During the conversation, the phone number of the incoming call of the third party can be seen in the unit.
This function can be worked when the user applied the Telecom service.
Flash
The flash function of FL/CLR key can support some special network service, such as call waiting, call transfer,
etc. These services require a subscription and the operations depend on the different exchanger.
Pause
Press RD/P key will insert a 3.6 seconds pause time between two digit numbers.
Pre-dialing
The unit has pre-dialing function, when you may enter and edit the number before dial it out.
The following procedure describes how to use this function:
1) In idle mode, enter the number you want to dial. During entering, you can press R/CLR key to correct the
number.
2) Press
key or key once, the unit will dial out the number show on the LCD.
Redial function
In idle state, press
key or key, press RD/P key, the last dialed number will be dialed again.
To Lock/Unlock the keypad
To lock the keypad
Press and hold the
key for about 2 seconds.
You will hear a beep tone, while the keypad is locked, any key you press is invalid.
To unlock the keypad
Press and hold the
key for about 2 seconds.
You will hear a beep tone, the handset will be unlocked and it will go back to idle mode.
MULTI-HANDSET OPERATION
Maximum 5 handsets can be linked to the same base unit. Maximum 4 bases can be linked to the same
handset.
If you have two handsets registered with one base, operation it by the follow ways:
 Intercom
The intercom feature is activated by pressing the
key.
1) In idle mode, press
key once.
2) The destination handset will ring, press
or key to enter conversation mode. To end intercom
mode, either handset can hang up the call by press
key.
 Call transfer
During a call, it’s to transfer the call to another handset.
1) During a phone call, press
key once. The destination handset will ring.
2) Press
or key of the other handset to accept the call.
3) The two internal handsets will be connected. To complete the transfer of the call, the initiating handset
should be placed on the cradle and the external call will now be connected to the second handset.