User's Manual

Transmission
CP07029
Model
LED indicator
Indicator Status Status
WIFI indicator (BLU)
Low-Battery
Indicator (RED)
On
Flash Slowly
Flash Rapidly
Blinking
Receiver
CP03029
Frequency indicator
Battery Indicator
Off
Red Indicator blinking
Yellow Indicator off
Yellow Indicator on
Connected
Waiting for connection
Start WPS coding
Low-battery
The number of blinks indicates
the current frequency value
No frequency switching
Low-battery
Battery full
Charging battery
Malfunction
Failure Cause
Solution
No Picture
The Receiver doesn’t power on
The Receiver doesn’t connected
to APP device
Exception connection between
Signal source and transmitter
Exception of transmitter
Image
Picture is not clear,
with noise and
mosaics
Exception of Receiver
Tx / Rx antenna are not erecte
The distance between Tx and Rx
exceed Effective transmission range
Power on the Receiver
Connecting receiver to APP
device over Wifi
Check up interface channel between
Signal source and transmitter
Restart the transmitter
Restart the Receive
Keep Tx / Rx antenna erect
Move Receiver closer to the transmitter
Reduce the solid walls between Tx and Rx
Move Receiver closer to the transmitter or
skip the obstacles
Solid walls between Tx and Rx
Too many obstacles between Tx and Rx
SPECIAL NOTICE
* Since the product's improving process, all the performance,
design and specifications of ourproducts are subject to minor
change without prior notice.
INDICATOR DESCRIPTION
WIFI indicator
On
Flash Slowly
Flash Rapidly
Blinking
Connected
Waiting for connection
Start WPS coding
TROUBLE SHOOTING
1.Although the product has provided the function of data encryption when
transmitting, you still need to pay attention to deliberate signal interception.
There will be the Possibility of a third party intentionally intercept the
transmission signal since the product adopt wireless communication.
Please do not use the product on confidential and important communications,
or life-related communications The main concern is that the content of
wireless communication might be received by the third party's wireless
devices deliberately or accidentally
2. The impact of radio waves (such as the following environment may cause
the abnormal audio and video(blocked image, noise ...etc.).
1 ) Transmit near the wall which is hard for the radio waves to get through.
2 ) Quite close to the refrigerator, metal fitment and appliances,
or next to the crowded situation.
3. This product has been tested and manufactured to comply with national
electrical safety rules, however, there will be noise caused by the
interference with other machines in rare cases. If the interference is
happened, please keep a certain distance away from other machines.
4. DO NOT turn the power on before the antennas are properly installed.
5. Please do not set up the transmitter and receiver in metal shelf,
or it will hinder the wireless communications.
6. It will take 15-20 seconds to boot the system before wireless
communication start, the media receiver can not be operated during this time.
iOS
Android
19 20