User's Manual

Rematch the code of transmitter and receiver.
Please contact your distributor.
Haven't matched the code of TX and RX.
Transmitter or receiver failure
Connect the transmitter with player by the HDMI cable.
Power on player.
Switch player to HDMI output.
Unplug and then plug the HDMI cable of the TX or player.
Change the HDMI cable
Reboot the transmitter.
Please contact your distributor.
Reboot the receiver.
Please contact your distributor.
Indicator status of wireless connection is on, but video Indicator is off.
Receiver and TV are not connected.
Player is not turned on.
Haven't switched player to HDMI output.
Poor contact of transmitter or player's HDMI cable.
There are problems with HDMI cable between TX
and player.
Indicator status of wireless connection is flash rapidly.
Abnormal working of transmitter
Transmitter failure
Indicator status of wireless connection is off.
Please refer to OSD information: Network connect failed, please check the device is ready.
Indicator status of wireless connection is on, but video indicator is off.
Please refer to OSD information: video connect failed, Please check the device is ready
Indicator status of wireless connection is flash rapidly.
Abnormal working of receiver.
Receiver failure
Reduce the number of solid walls between TX and RX.
Move the receiver closer to the transmitter.
Several solid walls partition transmitter and receiver.
There are too many obstacles between TX and RX.
Possible Reasons: Solutions:
Transmitter
Receiver
37 38
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, includinginterference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:-Reorient or relocate the receiving
antenna. Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. To assure continued
compliance, any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment. (Example use only
shielded interface cables when connecting to computer or peripheral devices).
FCC Statement
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modificationscould void the user authority to operate
the equipment.
FCC Radiation Exposure Statement
Cautions!