User's Manual

13 14
USB
HDMI OUT
POWER
HDMI
HDMI OUT
HDMI
RX:1.x.xx
1920x1080P Freq:5xxx
NETWORK CONNECTING...
VIDEO
NETWORK
H1
V2
HD Player
RX: 1.x.x x TX:1.x .xx
192 0x108 0P Freq :5xxx
NET WORK CO NNECT ED. VIDE O CONNE CTED.
Remote control
RX: 1.x.x x TX:1.x .xx
192 0x108 0P Freq :5xxx
NET WORK CO NNECT ED. VIDE O CONNE CTED.
VGA
HDMI
VIDEO
NET
WORK
H1
V2
HD MI O UT
USB
HDMI
HDM I OUT
HDMI
Transmitter
HD TV
HDMI cable
1.HDMI In
2.VGA In
90°
360°
VIDEO NETWORK
Barcket
Barcket
HD MI I N
HDMI
HD TV
Connecting to CB3801...
HDMI
IR Receiver
Receiver
3. Connect“HDMI OUT”port on CB2601's front panel to the HDTV1 by the HDMI
cable, the TV screen will show the content of default input source. Switch VGA /
HDMI input source by pressing code matching key shortly.
4. Connect the the receiver to tne HDTV2 by HDMI cable. Power on HDTV
and receiver. When the transmitter and receiver are properly connected and the
network has been connected, OSD information on TV screen will be prompted
as:"NETWORK CONNECTING ..."
5. Wait for 15 to 25 seconds, the network and video indicator will turn on, that is the
video connection is successful. OSD information on ( projector ) HDTV screen will
be prompted as NETWORK CONNECTED, VIDEO CONNECTED", and then screen
show the content of default input source. The program is show on TV1 and TV2
simultaneously.
Installation instructions for CB3801
1. Screw CB3801 with the bracket, rotate the screw clockwise until fix it, adjust
the receiver up and down, then fix it with proper angle, and twist the wrench
clockwise to fix the direction of receiver.
2.Connect the CB3801 with monitor by HDMI cable ,plug the IR cable into the IR
jack of receiver and use the supplied double sided tape to fix the IR head in the
front side of the monitor. Plug into the power supply of receiver, the OSD
information on TV screen will be prompted as: Connecting to CB3801”
HDMI cable
HDTV
Power supply Receiver
HD TV 1
Transmitter
HD TV 2
Receiver
Laptop
Power supply
Switch VGA / HDMI
input