User's Manual
19
20
NN
EE
TT
WW
OO
RR
KK
VV
II
DD
EE
OO
TX2:CB8801W
Stick0203
TX3:CW
SONY BD
B2601
TX1:CV6608W
DVB
RX2:CV3801W
RX1:CV6620W
HDTV1
HDTV2
VIDEO
NETWORK
H1
V2
Connected to Stick0203
Adding Stick0203
Press OK to continue or Exit to cancel
2
Trans mitter
Transmitter
Setup
Remove Video Source
Modify Video Source
Add new Video Source
Receiver
WHDI Remote Control
1
Adding Stick0203...
Connected to Stick0203
VIDEO NETWORK
5. Wait for 15 to 25 seconds, the network and video indicators will turn on, the
OSD information on TV screen will be prompted as the following picture and
the disappear in 3 seconds.
6. You can use WHDI remote control to select different transmitter (player)
OK
1
1
2
2
3
3
MENU
EXIT SOURCE
DELETE
ADD GUEST
INPUT
DEVICES
WHDI Remote Control
1 .MENU
2 .EXIT
3. SOURCE
4. Direction
key
5. OK
6. DELETE
7. ADD
8. GUEST
9. 1st Video
source
10. 2nd Video
source
11. 3nd Video
source
1
1
2
2
3
3
O
O
K
K
1. Enter the main menu
2. Return to previous menu
3. ENTER [Select Video Source]
4. Operate for up, down, left and right
directions on the menu screen
5. Press OK to confirm the operation
6. Enter [Remove Video Source]
7. Enter [Add New Video Source]
8. System powering down
9. Connect to 1st Video source
10. Connect to 2nd Video source
11. Connect to 3nd Video source
Add New Video Source (WHDI Product Code Matching)
WHDI supports multiple transmitters with one receiver. You can add additional
transmitters as refer to the following steps:
1. Press [MENU] key of the WHDI remote control to enter the main menu, press
direction key to enter [Add new Video Source] or press [Add] key to add video
source. Please make sure that the remote control is pointing to receiver's IR
sensor window at the operation process.
2. Press the code key of transmitter for 3~5 seconds and then loosen from the
code key, OSD information will be prompted as “Please Activate Registration
On Transmitter Unit”.
5. If there need to add more new video source, please repeat the above 1 to 4 steps.
3. Press [OK] key to enter the code
matching process.
4. The code matching will be completed
after about 30 seconds, and the video
source will be connected to automatically.
WHDI Remote Control Operation Instruction
Press the code keys
simultaneously for
3~5 Sec