Product Info

Printed model with poor edge quality. What are the appropriate
acceleration and speed settings when slicing?
1.Check that the printer is properly connected to the Creality Sonic Pad.
2.Check whether the power connection of the Creality Sonic Pad and the printer is normal.
Abort printing during printing
1. Enter configuration-camera to see if there is a real-time image, if there is no real-time image,
it should be turned on first;
2. Confirm that the camera is a general-purpose USB camera, and the real-time screen has
been turned on;
3. Enter Configure - Local Information to check whether the available storage is insufficient;
4. Check whether the time-lapse video has been turned on and whether the frequency of the
time-lapse video is set correctly. (the frequency should be less than the number of slice layers)
Time-lapse photography did not shoot successfully
The vibration sensor should be installed on the hotend . You can print the bracket which the
model file provided by Creality, and then use the screws to fasten the sensor to the bracket
without direction requirement.
Where should the vibration sensor be placed when resonance
compensation is automatically detected? Are there any orientation
requirements ?
You can refer to the slicing software configuration parameter suggestions provided by Creality.
The default supported printers (Ender-3 V2 / Ender-3 S1 / Ender-3 S1 Pro) can directly import
the corresponding parameter configuration files in the slicing software.
add in config file
[filament_switch_sensor filament_sensor]
pause_on_runout: true
switch_pin: ^!PC15
Notice! switch_pin needs to be confirmed as the connection PIN for the filamtent run-out sensor
How to configure the file to be compatible with filament run-out
detection function ?
1. Check whether the printer is powered on;
2. Check if the printer is flashing the correct firmware version;
3. Check whether the configuration file matches correctly;
4. Check whether the USB connection is stable.
5. Check whether the current version of the Creality Sonic Pad software is the latest version.
Can't connect to the printer successfully
22