Instruction Manual

display
"SOFT VER"
Eg．“V1.1.00”
9. Scan
In order to receive the calls from many channels, the radio can be programmed to scan
these channels. At most there are 16 channels in each scan list. Each channel can use a
scan list together with others or alone.
9.1 Start/End Scan Function
You can press “SCAN” button directly or enable the scan through the menu.
When the scan function is started,
icon and your revert channel will display .
1. Enter the scan state through menu mode.
A. Press the “Menu Selection/Enter” button to enter the menu mode.
B. Press
/ button until “SYS SCAN”.
C. Press
O
button for selection.
D. Press
/ button until “SCAN ON?” or “SCAN OF?”
E. Press
O
button for select.
2. Use the scan button.
A. Press “SCAN” button to activate the scan function.
B. Press “SCAN” button again to disable the scan function.
9.2 Nuisance Delete
If a channel continuously generates noise or interference, press the button to remove
this channel from the scan list temporarily.
Note: the priority channel can't be removed and the last one in the scan list, either.
9.3 Edit Scan List
9.3.1 Add or Delete the Channels in the Scan List
A. Press the “Menu Selection/Enter” button to enter the menu mode.
B. Press
/ button until “PROG LST”.
C. Press
O
button to select “SCAN LIST”.
D. Press
/ button until “ADD LST?” or DEL LST?”.
E. Press
O
button for selection.
F. Press
/ button until the channel you want to add or delete.
G. Press
O
button to complete operation you will see“CHNSAVE” (If you added a
channel)or“CHN DEL”.
H. Press
C
button to return to the previous operation.
9.3.2 Set Priority Channel
1. Press the “Menu Selection/Enter” button to enter the menu mode.
2. Press
/ button until “PROG LST”.
3. Press
O
button to select “SCAN LIST”.
4. Press
/ button until “ED PRIO?”.
5. Press
O
button for selection.