User's Manual
Table Of Contents
- Instruction Manual
- CU600-1 / CU600-2
- Two Way Radio
- CONTENTS
- 1、Open Package Inspection
- 3、Radio Overview
- 4、Basic Operations
- None
- Annunciation Type Selection
- CALL 1/CALL 2/CALL3/CALL4
- Lone Work
- Man-down
- Call Forward
- Squelch Adjust
- Monitor/ Call Cancel
- Squelch Off/ Call Cancel
- Battery Power Check
- FCS
- Normal Record/Record Stop
- Protect Record/Record Stop
- Record Play/Play Next/Play Stop
- Record Delete
- Top Button
- Side Button 1
- Side Button 2
2、Preparation
2.1
Charging the Battery
Plug the power adapter into the proper AC wall outlet; and insert the cable of the power adapter
into the adapter socket on the charger; Red LED flashes after it enters normal work.(Red LED
lights per 3 seconds)
Insert the battery or the radio to be charged into the charger slot. Turn off the radio before
insert it into
the charger.
Make sure the battery is in good contact with the charger terminals. When the red indicator lights,
the charger be
gins to charge the battery.
After charging for about 3 hours, the red indicator turns dim and the green indicator lights
indica
ting the battery has been fully charged.
Leave the battery in that sate of green indicator for 1~2 hours before you remove it from the
charger to a
chieve the best performance of the battery. Then you can disconnect the power adapter
from the AC outlet.
Red LED flashes quickly ( Red LED flashes 0.2s per 0.4 seconds) when charging temperature or
circuit
is abnormal and the charger enters protection state. Please stop charging in such situation.
Remove the batter from the charger and cut off charger power.
4