User's Manual

During scanning, if the priority channel has been set on the radio, when the priority channel
receives signals the radio will automatically switch to the priority channel even the normal
channel is receiving signals at that time. And the radio will stay on the priority channel till the
signals disappear. The dealer can set the delay time between signal disappearing and continuing
scanning.
Temporarily Delete Noise Channel
When scanning pauses on a channel, press and hold the button programmed as “Temporarily
Delete
Noise
Channel” to delete this channel temporarily from the scanning list.
Note: The priority channel cannot be deleted. And when the number of scanning channels is
less th
an 2, you cannot delete any channel, either.
After exiting scanning mode and entering it again, the temporarily deleted channel will be added
in
the scanning list again.
Call Forward
This function enters mode whereby an individual ca
ll
causes the radio to transmit the call forward
telegram. This feature is used more on mobile radios and it allows the user to leave the vehicle. If
the vehicle receives an individual call ,it will transmit a telegram to the forwarding radio. This
radio will open .Assuming both radios have the same PL , the call will take place.This function is
only used in 5-tone mode
H/M/L Power Switch
Press the key set as “H/M/L Power Switch” to switch among high ,middle and low power.
A alert heard, meaning high. Two alert heard, m
eaning
middle power. Three alert head, meaning
low power.
Squelch Adjust
You can increase one squelch level if you press once (9-0 cycle,0 level have a "beep" and then
squ
elch remains long active ),and save it.
Monitor Momentary/Ca
ll Ca
ncel
Press the side button set as “Monitor Momentary” to turn off CTCSS, DCS, 5-Tone, 2-Tone and
MDC an
d to hear the signals that cannot be heard when in normal work. Release the Monitor key
to return to normal work.
When in selective call state, press this key to exit selective call.
Monitor/ Call Cancel
Press the side button set as “Monitor” to turn off CTCSS, DCS, 5-Tone,2-Tone and MDC and to
hear th
e signals that cannot be heard when in normal work. Press again the Monitor key to return
to normal work.
When in selective call state, press this key to exit selective call.
Squelch Momentary/Call Cancel
Press the button set as “Squelch Momentary” to turn on the squelch; release it to exit.
When in selective call state, press this key to exit selective call
13