User's Manual
Table Of Contents
- Instruction Manual
- CU600-1 / CU600-2
- Two Way Radio
- CONTENTS
- 1、Open Package Inspection
- 3、Radio Overview
- 4、Basic Operations
- None
- Annunciation Type Selection
- CALL 1/CALL 2/CALL3/CALL4
- Lone Work
- Man-down
- Call Forward
- Squelch Adjust
- Monitor/ Call Cancel
- Squelch Off/ Call Cancel
- Battery Power Check
- FCS
- Normal Record/Record Stop
- Protect Record/Record Stop
- Record Play/Play Next/Play Stop
- Record Delete
- Top Button
- Side Button 1
- Side Button 2
After pressing this key, the radio will transmit with the RX frequency.
CALL 1/CALL 2/CALL3/CALL4
Press the side button set as “CALL 1/CALL 2/CALL3/C
ALL4” to transmit the stored coding.
Lone Work
When the radio is set in lone work, it will sounds pre-alert tones before the Lone Work time
expi
res, and the user should press any key on the radio within the Reset Time, indicating the user
is safe, otherwise, the radio will activate emergency alert automatically.
Emergency Call
When you press the top button set as “Emergency Call”, the radio can sound alarm tone or
transm
it ID
code or background tone to your partners or the system, both of which can be chosen
in radio programming with the software.
Cancel Emergency Call
Press the top button set as “Cancel Emergency Call” to cancel Emergency function.
Man-down
Press this key to enter man-down “Emergency call” mode, which is optional function.
Scan
a) Press the butt
on se
t as “Scan” to start scanning. When in scanning, the radio checks signals on
each channel; it stops scanning and pauses on the channel on which signals are detected until
the signals disappear. If a delay time has been set between the interval of signal disappearing
and scanning restarting, the radio will keep staying on that channel if it receives any signals
during the delay time.
b) The
working channel of the radio will revert to the following channels automatically when
y
ou press PTT button during scanning. The dealer can select one among the following six
options.:
1) Start channel Ch
When pressing PTT button, the radio will transmit on the channel for which the scan list
applies
.
2) Designated TX Ch
When pressing PTT button, the radio will transmit on a programmed designated channel,
which d
oes not have to be part of the scan list or the channel to which the scan list
applies.
3) Last called
When pressing PTT button, the radio will transmit from the last channel that received a
call.
4) Last used
When pressing PTT button during the scanning, the radio will transmit from the last
chan
nel you used to talk.
c) Priority Scan
12










