User's Manual

transmitter then press “F1+F2”key，Then restart up，after the prompt letter then
release F1、F2，then start up again.
4、Transmitter paging lose message
Reason：During paging, check the paging icon position, which would display the
queue number. The treatment Max number is 40pcs. The data over 40 would be
discarded.
5、The transmitter sending message too slowly
Reason：Pay attention to the sending time interval and the heart beat data setting. The
heartbeat interval sending should slow at least 3 times of the normal sending data
interval. Otherwise, it would resend only after the heartbeat sending many times later.
6、The coaster pager couldn't light
Reason：
（1） Put the coaster pager onto the charger to check whether the coaster pager
electricity.
（2） If the electricity is enough, swing the coaster pager (NiXie Tube dead
against yourself)
（3）To check whether the battery is aging
7、The coaster pager couldn't charge
Reason：
（1）The coaster pager would only charge when the electricity is lower than
80%.
（2）check whether the charging power is on, and the red indicator light in the
charger is on.
（3）Check whether it put correctly.
7. FCC Important Note
FCC Part 15.19 Warning Statement
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
25