User's Manual

picture 4.2 Staff Calling interface
In the staff calling interface, the method of inputting SN is the same as paging
the customer. The only difference is that the message input in this interface message
input box as the sending message. After the number was input, press the "ENT" to
enter into the message edition interface, in this interface it would show the fixed
message. When the cursor move to the fixed message, it could page turn. The chosen
message SN would be shown in the message inputting area, at this time, click the
"SEND" key, the SN+ message SN would be sent out. If want to send the message,
after chosen the message, click "ENT" , then the chosen message would be shown in
the message area, at this time, you could edit the message through the keys. Press the
SEND, the message would be sent. If the message exceed the message area capacity,
it would show part content. At the same time, could page turn the message through the
pg up & pg dn. When pg up to the top，press the pg up, the cursor would turn to the
fixed message area, and the message display area message would be cleared and show
the fixed message Number.
Class Paging
It support the class paging operation in the staff single calling interface. The
class Paging in this interface are all of the staff which stored the parameter in the
transmitter. The operation is the same as customer class paging, Number "0" as class
14