User's Manual

IV System parameter

Requester capability 199

Number restriction 01-99, or A0-J9

Coverage of the requester 100m (open air)

Requester frequency 433.500MHz

Requester transmit power <30mW

Requester power supply (2610N3 /2610E3) 4.5V, 3 No.7 batteries/ 12V, 1 No. batteries

Host receiving sensitivity -105DB

Host power reply AC 220V/DC 12V

Decode time 1-2s

Requester antenna inside

Host antenna Inside

Code mode Self study

V. Setup

Power on the host first, and all the numbers will be “8”. then the host will display

—HOST----，and then the volume grade. And then it comes to working mode, on which you

can set it.

1）Set requester number:

a. On working mode, Press the ENT button on the host for 4 seconds without release, then

the host displays 01 SET , which means it comes to set mode.

b. Now the screen displays 01 SET, the low digit-1 is flashing, means this place can be

modified to any figure from 0-9 by“ALT/-”button on host , “TAB/+” button can change

the flashing digit. E.g., move to high digit, you can modify it to any figure from 0-9 and

any letter from A-J by“ALT/-” button. Its total capacity is 199 numbers.

c. After modifying number to what you want, e.g. 16 SET, press “ENT” button, then the

screen displays 16 PUSH, prompt you to press button of the requester.

d. Press the button of the requester within 5 seconds; the screen will display 16 OK,