User's Manual

1.The standard power supply ranges from 9V to 36VDC. Please use
the power cord manufactured by the original factory. Red line means
positive side while black line means negative side. During
installation, negative side should connect to the ground, do not
connect with other ground wires at the same time.
2.ACC line (orange) connects to vehicle's ACC switch, detecting
ignition on and off.
3.Device's oil and electricity control line (yellow) connects to relay's 86.
(thin yellow line of relay socket)
Wiring Instruction
Relay wiring instruction
Relay wiring way of oil pump open circuit: On each end of the wire is thin
white line (85) and thin yellow line (86). Thin white line (85) connects to
the positive side of battery (12V) while thin yellow line (86) connects to the
device relay control. There is an oil pump in the vehicle. Cut off the
positive line. The positive side of oil pump connects to the close-end of
relay.(Thick green line 87a), and the other side connects to relay's
common(green thick 30).
Notice
12V relay is standard. The device is suitable for vehicles with 12V
battery. If the vehicle has 24V battery, then 24V relay is needed.
4.To monitor analog signals, the purple line (ADC) of extended port
should be connected to the analog line.
5.To check status of car door, orange line (IN1) should be connected
to where between the door light and door switch (See the diagram).
6.To find car remotely, please connect the yellow line (OUT1) of
extended port to external relay.
Wiring instruction for remote trigger car light and buzzer
Thin white line (85) and thick green line (87) of relay should be connected
to car battery's positive pole. The thin yellow line (86) is connected to the
yellow line (OUT1) of extended port. Cut off the line of car turn light first
and then connect one side with turn light to the common terminal (thick
green line 30) and other side to closed terminal (thick green line 87a). See
diagram for wiring way.