User manual

Strona 6 z 10 rev. 1.0.1
USER MANUAL: GT03B GPS PORTABLE TRACKER
www.elmic.p
l
,
[e-mail]
Device functions and Parameter setting
1. Settings of APN
To set up the APN parameter, please send SMS command to the number of device. The device will reply “OK”
automatically after setting successfully. The SMS command is as following:APN,APN’s name#
E.g: APN,internet# (“internet” is the APN of carrier)
The device will reply “OK” if setting successfully.
Note: The APN of some countries have user name and password, you may need to send SMS command as following:
APN,APN name,user name,password#
E.g: APN,internet,CLIENTE,AMENA#
2. SOS numbers setting
5.2.1 Add SOS number
SMS command: SOS,A,number1,number2,number3,number4#(A means add number). You could set 4 SOS numbers in
maximum
For example:
SOS,A, 13510682360,13511685136#(set 2 SOS numbers)
SOS, A,13510682360,13511685136,13612687248,13612683621# (set 4 SOS numbers)
It will reply “OK” if suceeded.
You can set SOS numbers via the platform after activating the device.
3. Delete SOS numbers
SMS: SOS, D,1,2,3,4# (D means delete SOS number)
For example: SOS, D,1# means delete the first number
SOS,D,3# means delete the third number
If you do not know the serial number, you can also delete number by SMS command like this: SOS, D,number#
For example: SOS, D, 13527852360# means delete this SOS number directly.
It will reply “OK” if succeeded to delete this number.
Note
：
Remotely arm/disarm, remotely monitor, checking location via SMS and receiving SOS alarm from device
must be functioned by SOS numbers only, which are pre-set.
You can set SOS numbers via the platform after activating the device.
4. Arm /Disarm
Three ways to arm/ disarm:
i. Via Parking button
Slide PK switch to “ON” to arm the device. The three LEDs will slowly circulation flashing. The device will be armed after 3
minutes. The 3 LEDs will quickly circulation flashing.
Slide PK switch to “OFF” to disarm the device.
ii. via calls
Any SOS number calls to the device (must be the SOS number), and then end up the call in 10s by the mobile side to arm
the device. The device will reply a SMS message “OK”. If the SOS number does not end up the call in 10s, it will turn to
monitoring function.
Any SOS number calls to the device (must be the SOS number), and then end up the call in 10s by the mobile side to
disarm the device (if the device is armed before). The device will reply a SMS message “OK”. If the SOS number does not
end up the call in 10s, it will enter monitoring function.
iii. via SMS command
Any SOS number can send SMS command “111” to arm the device (must be the SOS number). And the device will
automatically reply “OK” if it set successfully.
Any SOS number can send SMS command “
000” to disarm the device (must be the SOS number). And the device will
automatically reply “OK” if it set successfully.