USER MANUAL NAME: GPS PORTABLE TRACKER GPS + GSM + SMS / GPRS MODEL: GT03B PLEASE READ THE INSTRUCTIONS BEFORE USING THE UNIT. SAVE IT FOR USE IN THE FUTURE. www.elmic.pl, elmic@elmic.pl Importer: Przedsiębiorstwo Handlowo Usługowe FENIKS Cyprian Pawlaczyk ul.
Safety Warning & Attentions .................................................................................................................................................... 3 1. Attention ...................................................................................................................................................................... 3 2. Attention for operation of this product ............................................................................................................
Introduction Thank you for choosing this GPS Portable Tracker. Please read this Manual carefully to fully understand its usage, perfect functions and simple operation. The Company reserves the right to modify this Manual from time to time without prior notice. Before using this product, please read these Attentions carefully to ensure safe and proper operation of this product. Safety Warning & Attentions 1.
mini USB 2. Appearance: ON / OFF Switch Parking GPS Indicator GSM Indicator SOS button / Power Indicator 3. Usage: • • • • • • • • • for person for bikes for cars for vans for trucks for camper for buses for motorcycle for other vehicles 4.
. LED Indicators Status: GPS LED Indicator – Blue Status Implication Quick Flashing (interval 0.1s) Searching GPS signal Slow flashing (flash 0.1s after every 2s ) GPS signal has been acquired successfully Continuously in dark GPS stop working GSM LED Indicator – Green Status Implication Flashing (flash 0.1s after every 1s) Receive GSM signal normally Slow flashing (flash 0.
Device functions and Parameter setting 1. Settings of APN To set up the APN parameter, please send SMS command to the number of device. The device will reply “OK” automatically after setting successfully. The SMS command is as following:APN,APN’s name# E.g: APN,internet# (“internet” is the APN of carrier) The device will reply “OK” if setting successfully. Note: The APN of some countries have user name and password, you may need to send SMS command as following: APN,APN name,user name,password# E.
5. Vibration alarm When the device is in arm state, vibration will activate alarms. The device will send vibration alarm to the SOS numbers in 10s. If the GPS is located, the device will send accurate address information. If GPS is not located, the device will send LBS address information. If GPS is located in 5 minutes, the device will send accurate address information. Example of GPS address information: “vibration alarm: Bao’an Road, Bao’an District, Shenzhen, Guangdong (N22.57139,E113.
iii. Check geo fence If want to check status of geo fence, send SMS command "SEEFENCE#" to device from any number. If geo fence is not active, it will reply SMS "Switch: OFF" If geo fence is active, it will reply SMS "Switch: ON;State:IN&OUT;Lat:N22.567000;Lon:E113,890000,Radius:100M;FenceT ype:Circle;" 8.
11. Factory recovery settings SMS command: FACTORY# When device gets command, it will recover parameters into default value. 12. Reboot device SMS command: RESET# When device gets command, it will reboot after 1 min. Troubleshooting If there is trouble during using the phone, please read the solution as follow or contact provider. Common problems Causes Solution Change to a place with good signal.
Warranty instructions and service 1. The warranty is valid only when the warranty card is properly completed, and upon presentation of the proof of purchase consisting of original invoice indicating the date of purchase, model and serial No.of the product. We reserve the right to refuse warranty if this information has been removed or changed after the original purchase of the product from the dealer. 2.
