User's Manual

19
6.32. Set up Terminal (local) Time
Send SMS command “time+space+zone+password+space+time” to the tracker unit, If succeed, It will
reply “time OK”
For example: Send SMS “time zone123456 8”, 8 is Chinese time zone, If your country time zone is
minus, send SMS “time zone123456 -8”.
6.33. Reset Hardware
Send SMS “reset+password” to tracker device, it will reply “reset ok”. And the GSM module and
GPS module in the tracker will be reset.
6.34. Configure parameters by USB
Connect tracker to computer with the optional USB cable, open the memory of the tracker, find the initial
configuration file, copy to your PC and open it with notepad
, then operate according
to the instructions and save it, copy back to memory to overwrite it and it will take effect immediately.
Note: Correct password is needed every time you configure the tracker.
6.35. GPRS setting
User must send SMS via cell phone to set up IP, port and APN before starting GPRS.
6.35.1 Setting up APN
APN standards for Access Point Name and differs from country to country. For more information about
the local APN, inquire with your local GPRS network operator.
Text the tracker a SMS “APN+password + Space + your local APN” via a cell phone and if succeeded
in setup, the tracker will return the message “APN OK”.
e.g. send SMS command “APN123456 CMNET”. If succeeded, “APN OK” is returned by the tracker in
SMS.
Notes: 123456 refer to password of tracker and CMNET is the APN of China Mobile (One of GSM
Operator in China).
6.35.2 GPRS User ID and password Setup