User's Manual

number in 3 minutes when the sensor is triggered in arm status. Within 3 minutes, the
alarm siren sound for 5 seconds when the vibration is detected in the first time and
second time. The alarm siren sound for 10 seconds when vibration again. If you disarm
the tracker, the times will reset.
Disarm to stop this alarm.
6.28.4 Built in Acceleration Sensor Alarm
The tracker is built in three axis acceleration sensor, the tracker can detect it in arm state
when the vehicle move, tilt or shock. The alarm way is same as the external shock
sensor alarm.
Disarm to stop this alarm.
Built in Shock sensor sensitivity configuration
The sensitivity of the built-in shock sensor has three different level:
First level: Alarm will be triggered after detect slight vibration, send command"
sensitivity+password+space+1" .
Second level: Alarm will be triggered after detect 8 times vibration in 2 seconds, send
command" sensitivity+password+space+2".
Third level: Alarm will be triggered after detect 25 times vibration in 5 seconds, send
command" sensitivity+password+space+3".
6.28.5 Alarm without WCDMA/GSM network service
When the car is in the place without WCDMA/GSM network service, siren will be
sound under non-silent mode if alarm is triggered (door, sensor, ACC), but no SMS
alarm will send to authorized number.
6.29 Sleep Mode
SMS Mode GPRS Mode Set Less GPRS Traffic in GPRS Mode
No
Sleep
Work Online
ACC Off. No Calling, SMS and any
triggered alarm, GPRS disconnect and switch
to SMS mode, sleep. ACC on or Calling,
SMS and any triggered alarm can awake it,
and GPRS connect
Sleep
ACC off. No Calling,
SMS and any
triggered alarm, go to
sleep, GPS module
shut off,
WCDMA/GSM
Online
ACC Off. No Calling, SMS and any triggered
alarm, GPRS disconnect and switch to SMS
mode, go to sleep. ACC on or Calling, SMS
and any triggered alarm can awake it, and
GPRS connect.