User's Manual
Table Of Contents
- Summary
- 2. Applications
- 3. Hardware Description
- 4. Specifications
- 5 Start to use
- 6. Function details
- Changing password
- Authorization
- Single tracking
- Continuous interval tracking
- Smart angle updating
- GPS drift suppression
- Exact street address
- Location based service (LBS) / Cell-ID tracking
- Forwarding incoming SMS messages
- SIM Card Balance Enquiry
- ACC ON/OFF Alert
- Remote immobilizing (For BC model)
- Configure times of alarm SMS
- Alarms
- Remote control function (For C model)
- Arming
- Silent Arming
- Disarming
- Alarm function in arming state
- Sleep Mode
- Check Status
- Check IMEI
- Local time setting
- Reset Hardware
- Configure parameters by USB
- GPRS configuration for live real-time tracking
- Configure SMS management center number
- Configure heartbeat package interval
- Initialization
- 7. Cautions
- 8. Troubleshooting
6
5.1 Terminal installation
Please ask a qualified engineer to install it.
The installation environment should not exceed the GSM performance index.
Please do not install it in a dusty and humid environment.
Find the wiring harness provided with the product, insert it into the
corresponding wiring hole of the product, and connect to the original car
circuit as shown in the following figure:
The orange wire can be connected to the original car horn; it can also be
connected to the siren bought with the tracker .
Wiring Diagram
5.2 SIM card installation
Note: Please make sure the SIM card is for GSM network and able to execute the
function of incoming calls display, no calls can be diverted and the PIN code is
locked. The SMS format must be TXT format, device can’t recognize the PDU
format.Proposed data flow package no less than 30MB per month.