User's Manual
Table Of Contents
- Summary
- 2. Applications
- 3. Hardware Description
- 4. Specifications
- 5 Start to use
- 6. Function details
- Changing password
- Authorization
- Single tracking
- Continuous interval tracking
- Smart angle updating
- GPS drift suppression
- Exact street address
- Location based service (LBS) / Cell-ID tracking
- Forwarding incoming SMS messages
- SIM Card Balance Enquiry
- ACC ON/OFF Alert
- Remote immobilizing (For BC model)
- Configure times of alarm SMS
- Alarms
- Remote control function (For C model)
- Arming
- Silent Arming
- Disarming
- Alarm function in arming state
- Sleep Mode
- Check Status
- Check IMEI
- Local time setting
- Reset Hardware
- Configure parameters by USB
- GPRS configuration for live real-time tracking
- Configure SMS management center number
- Configure heartbeat package interval
- Initialization
- 7. Cautions
- 8. Troubleshooting
32
No alarm
notification
message
1. Authorized number has not been set up.
2. The format of the phone number is incorrect.
Fail to stop engine
1. Please check whether the engine stop wiring connected correctly?
2. Please check whether the speed is higher than the speed to
execute the stop command when using Delay execution way?
Remote control
cannot be used
Turn off tracker, and turn it on to program the remote control again.
Siren doesn’t work
This tracker dri
ves the speaker output voltage DC12V/24V/1A, if it is
a negative trigger speaker, it will not be driven.
Manufacture： Shenzhen Coban Electronics Co.,LTD
Address:602 &702, Bldg. C2, Xinqiao Industrial Park, Tongfuyu Industrial Area, Xinhe Avenue, Gonghe
Community, Shajing Sub-District, Bao'an District, Shenzhen, Guangdong, Chin
FCC Warning
Any
Cha
nges or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device m ay not caus
e harmful interference, and (2) this device must accept any interference
recei
ved, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to pa rt 15 of the FCC Rules. These l imits are de signed to pr ovide r easonable pr otection against harmful
interference i n a r esidential installation. This equi pment ge nerates, uses and can radiate r adio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio c ommunications. H owever, there is no gua rantee that i nterference w ill not occur i
n a particular
insta
llation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
—Reorient or relocate the receiving antenna.