Users Manual Part 2

4.3.3 Use Instructions
Tap and hold the button to power on the machine. Then, the
power indicator is on, and the vacuum cleaner enters the standby
state. When the vacuum cleaner is in a static state, press and hold
the button to power off the machine and stop the current
cleaning task.
Tip:
The vacuum cleaner in charging state cannot be powered off.
Press the button to start cleaning. Then, the vacuum cleaner
dynamically plans the cleaning route according to the map generated
after scanning, and completes cleaning of different zones one by one.
In each zone, the vacuum cleaner first sweeps the floor along the wall,
and then moves in zigzag mode to clean the remaining part of the
zone in an orderly and efficient manner.
Start cleaning
Power on and off the machine
Zone 1: Cleaned Zone 2: Cleaned
Zone 3: Cleaning
Zone 4: To be cleaned
Tips:
* If the power is too low, the vacuum cleaner cannot start cleaning.
Therefore, charge the vacuum cleaner before starting it.
* Before cleaning, tidy up all kinds of wires on the ground (including
the power cord of the docking station). Otherwise, the vacuum
cleaner may drag the wires while cleaning, which may cause power
failures of other electric appliance or damage to items or wires.
* If the cleaning area is less than 2 square meters, the vacuum
cleaner will clean the area twice by default.
* If the power is insufficient in the cleaning process, the main unit will
automatically return to the docking station for charging. After the
power is sufficient, the main unit will automatically return to the
interrupted point to continue cleaning (ensure that you have enabled
the resumable cleaning function).
Pause cleaning
If you need to add water to the water tank or wash the mopping cloth
while the vacuum cleaner is working, press the button to pause. You
can pressthe button to continue cleaning, or pressthe button to
return to the docking station and stop the current cleaning task.
Tip:
In pause state, if the vacuum cleaner returns to the docking station for
charging, the current cleaning task is stopped.
If no operation is performed in 10 minutes, the vacuum cleaner
automatically enters the sleep mode, and the power indicator blinks every
several seconds. In sleep mode, you can press any button to wake up the
vacuum cleaner.
Tips:
* When the vacuum cleaner is being charged at the docking station, it
cannot enter the sleep mode.
* If the sleep time exceeds 12 hours, the vacuum cleaner automatically
powers off.
Enter the sleep mode
-15-