Instruction Manual

HOW TO USE
Note: Please charge before using the product!(Limited charge current of Adapter need
under 1A)
1.Charge the remote control:
1) Connect the charger cable to the charging port.
2) Plug the charger into a standard outlet.
3)The icon of battery will flash.
4) Charge the remote control for about one hour for the first charge or
until the icon of battery stops flashing.
2.Charge the collar receiver:
1) Connect the charger cable to the charging port.
2) Plug the charger into a standard wall outlet.
3) The red light will flash on the receiver
4) Charge the receiver for about one hour for the first charge or
until the red light of receiver goes off.
3.Connect remote control and receiver
1) Turn on the remote control. and press "1/2" button to choose channel 1 for pairing.
2)Press the power button on the receiver the RED light will show.
3) Push arbitrarily on the static shock or vibration or beep button, and then the receiver collar will emit a
“shock ” or "vibration" or "beep"
Note: The Green light will flash continuously, it sign that the pairing is successful.
4)If the pairing were not successful, please repeat the 3-5 steps.
5) To encode the second receiver, press the "1/2" button and
select for the second receiver and follow the same procedure.
5