User's Manual

Adjust Time & Light Sensitivity
The TIME and LIGHT knobs is at the right side of the battery compartment. TIME knob is on the
top and LIGHT knob at bottom
Time, The length of time that the lights stay on is adjustable from 30 minutes to 4 hours. Turning
the knob marked with TIME to set the time by using the diagram as a guide. In the fully
counter-clockwise position, the sensor turns off the lights 30 minutes after no movement detected.
In the fully clockwise position, the sensor turns off the lights 4 hours after no movement detected.
Light Level, The sensor can be prevented from turning on lights when there is already enough
light in the room. Turning the knob marked with LIGHT to set the light level using this diagram
as a guide. In the fully counter-clockwise position, the sensor turns on the lights even in fully
daylight. In the fully clockwise position, the sensor only turns on lights when the surrounding light
level is very low.
To adjust the photocell,
a. When the light in the room is at the level you want the lights to turn on.
b. Put the TIME control to 30seconds(fully counter-clockwise)
c. Put the LIGHT control to the minimum dark(fully clockwise) position. Wait for the LED
indicator does not flash any more.
d. Turn the LIGHT adjustment counter-clockwise in very small steps and wait 2 seconds
before moving your hand in front of the sensor. Repeat until the LED indicator flashing by
the sensor come on. The light will now come on when the light level is at below the
present level and motion is detected.
Manual ON/OFF Operation
Manual ON, Pressing the button under the motion eye, the output will be ON instantly
and continuously. The LED indicator will be lighted always.
Manual OFF, Pressing again the button under the motion eye, the output will be OFF
instantly and continuously. The LED indicator will be off always.