Installation Instructions

FCC Warnning:

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference in a residential installation. This equipment

generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can

be determined by turning the equipment off and on, the user is

encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

Caution: Any changes or modiﬁcations to this device not

explicitly approved by manufacturer could void

your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this

device must accept any interference

received, including interference that may cause undesired

operation.

The device has been evaluated to meet general RF exposure

requirement. The device can be used in

portable exposure condition without restriction.