Cadence and Speed Sensor User Manual Model: CDN200
Thank you for selecting this Cadence and Speed Sensor! CDN200 can track and monitor your cadence and speed on APP.
&5 Fix Ring x 3 Battery CR2032 x 1 Mode select 1. Cadence mode: the Blue LED is on to indicate the unit is on cadence mode when power up 2.
3. To switch cadence and speed mode , just need reinstall the battery . How to install the cadence and speed sensor on your bike It’s recommended you secure your bike on a stand while installing the sensor. Installing the cadence sensor 1. Place and hold the crank rubber pad on the inside of the non-drive side crank arm , then place cadence sensor . 2.
3. Rotate the crank arm to check for clearance. Take a few minute test ride and inspect the sensor to ensure there is no interference. Installing the speed sensor 1. Place and hold the wheel rubber pad and speed sensor on top of the wheel hub 2. Tied the sensor and hub with the silicone ring 3. Rotate the wheel to check for clearance.
How to track and monitor your data 1. First time you choose you prefer APP to install your smartphone such as Polar beat, Wahoo Fitness, Endomondo Runtastic PRO, Zwift. X-fitness etc. Wahoo Fitness Polar Beat Zwift X-Fitness 2. Then you connect the sensor to your device using Bluetooth® technology, it need pair when you start .
How to replace the battery The device uses one CR2032 battery. APP will remind that a low battery level and need replacement &5 &5 1. Twist the cover counterclockwise until the cover is loose enough to remove. 2. Remove the cover and the battery . 3. Insert the new battery into the cover, observing polarity.
NOTE: Do not damage or lose the O-ring gasket. 4. Twist the cover clockwise so that the marker on the cover aligns with the marker on the case. 5. NOTE: The LED flashes Blue to indicate that is cadence mode, RED is for Speed mode. Specification Dimensions Weight Battery 38.5x38.0x12.0mm 10.
Battery life Water proof 6 months at 2 hours Responsible per day time IP67 Detected range 2s 300 RPM Troubleshooting If your device will not connect to the speed and cadence sensors, you can try to Rotate the crank arm or wheel two revolutions to wake up the sensor. Or check battery level via APP and replacement • need reinstall battery if no LED flash when replace battery.
Directive RED 2014/53/EU. A copy of the signed and dated Declaration of Conformity is available FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
