User's Manual

channel light flashes, then press the programming key and function keys to complete
programming. The channel light is long after the setting is complete (for example: after entering
the programming mode, press the △ key then press F1 key, the light is long, then F1 function
becomes △ key); If in programming mode, no programming operation, after 10 seconds to exit
the programming mode, restore the last programming function, the channel light is long.
2) Clear programming key operation: the controller in the Bluetooth online state, press and hold the
combination key “SHARE+ Fn” key for 5 seconds, the channel light flashes fast, after 5 seconds the
light is long. at this time the programming function is cleared, Fn key to restore the default function
(F1 = L1, F2 = R1).
3) Programming key memory function: the controller programming is complete, the last
programming function is still retained after shutdown and reboot, Fn factory default (L1, R1).
4) The programmable keys are: △, ○, ╳, □, Up, Down, Left, Right, L3, R3, L1, R1, L2, R2.
5. Gamepad On / Off / Charging/Sleeping
1) Short press the PS button on the Controller, will be turned on; long press the PS button for 10
seconds, the controller light is off then shut down, or the controller can also be shut down by
logging out at the console side.
2) If the controller is in a low battery, the console will show zero power and the indicator light will flash;
at this time through the USB cable connection charging, the console will show the charging
progress bar and three cells of power when fully charged.
3) The controller is charged in the off state, the indicator light will show an orange breathing light and
cycle through the display, when fully charged, the light goes out.
4) The controller connects back to the console after powering on, more than 1 minute without