Users Manual

功能介绍
Function Introduction
开机：
Start-up:
对耳拿出充电盒自动开机/关机状态下短按开机键 1S，蓝灯常亮 1S，耳机提示语音听到“power on”此时耳
机进入回连状态，如附近有曾经配对连接过的设备，将自动回连至该设备，如无设备，等待约 5 秒 L 主耳
自动进入设备配对状态，红蓝灯交替闪烁；
Take it out from the charging compartment to power on automatically/short
press the POWER button for 1 second when it is off, the blue light will keep on
for 1 second, and voice is heard from the headset, which prompts: “Power on”,
at this time the headset enters the reconnection status. If there is any device
nearby that has been paired and connected, it will automatically reconnect to
the device. If no such device, its left earphone (L) will enter the automatic
pairing after about 5 seconds of waiting and meanwhile the red and blue lights
flash alternately.
进入耳机互相配对状态（同时回连）：
Enter the headset pairing mode (and meanwhile reconnect):
耳机开机后自动进入对耳互配模式（出厂默认都已经配对完成的），恢复出厂设置自动进入互配模式，红
蓝灯同步快闪，听到提示音“叮叮叮”耳机进入配对状态，双耳配对成功后，L 主耳机自动进入设备配对模式，
红蓝灯交替闪烁，提示音：“pairing mode”
The headset will enter the automatic pairing after power on (paired well by
default). Restore the factory settings and then automatically enter the pairing
mode. Then, the red and blue lights flash synchronously. When the prompt
tone “Beep” is heard, the headset enters the pairing state. After both the