Installation Instructions

A2
wireless earbuds
1.Play/pause music: touch L/R on either side
2.Left ear: double-click the previous song /
triple-click to reduce the volume
3.Right ear: double-click the next song /
triple-click to increase the volume
A2
1hours
15m
If your cellphone can't find'A2',please double check that your cellphone
Bluetooth is at visible mode.The earphone will automatically pair after
initial repairing,but if no use for a long time ,it must be paired again.
Charging: Charging box and earphones, the red
light is on
Fully charged: Charging box and earphones, the
red light is off
Socket type：TYPE-C
8-10hours
4.. Start SIEI: four click the L/R on either side
5.Answer the call: touch any side
6.Reject call: touch either side for two seconds
Charge times : 4 times
First link: Press and hold the touch button for
3-4 seconds to turn on the earbuds At this time,
the two earphones will flash red and blue. When
one of the lights goes out, the earbuds will enter
the pairing state. Click "A2" on the phone to
link successfully.
Power on: long press for 3-4 seconds
Power off: long press for 5 seconds
Headphone reset: long press for 10 seconds to
reset and restart the headphone (to prevent the
headset from crashing)
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.