Operator's Manual

3-3
If you have not purchased a thermal recorder base, device
preparation includes the following steps:
1. 错误!未找到引用源。
2. Using the DC Power Source
3. 错误!未找到引用源。
4.
错误!未找到引用源。
5. Login and Account Management
6. Connecting the Printer
7.
错误!未找到引用源。
3.3.1 Using the Battery
The device can be powered by a rechargeable lithium battery. When
a battery is installed, the device will automatically run from battery
power in case of power failure of the DC power supply or the
recorder base.
 Installing the Battery
To install or replace the battery, follow the steps below:
1. Press and slide the battery compartment cover lock/unlock latch
to the unlock position.
2. Push down to remove the battery compartment cover.
3. Place the battery in the battery compartment.